A versatile vocal mic with the largest dynamic element in a hand-held, the Heil Sound PR 35 features a 3-position roll-off switch and virtually no off-axis coloration. The Heil Sound PR 35S has been designed for recording, live sound reinforcement, and commercial broadcast applications that require a smooth, flat response over a wide frequency range. The PR 35S was designed around the acclaimed PR 30 element and incorporates a Sorbothane shock mount to give the best possible results. The PR 35S achieves its exceptional performance by using a special magnet structure and a large aluminum 1-1/2″ low-mass voice coil assembly. A carefully wound and placed hum bucking coil allows the PR 35S to be used close to video monitors without unwanted hum or buzz. Special attention has been paid to the phasing plug assembly with equally placed ports that sense audio from behind the source. It then enters them out of phase thus producing a very linear cardioid pattern. This reduces the proximity effect while achieving the extreme articulation across its smooth 40Hz-18kHz frequency response. The new Heil element can be used in extremely high sound pressure levels and is immune to overload conditions. It produces a beautifully smooth audio response without the inconvenience of phantom or outside DC powering. The PR 35S has a cardioid pattern that offers the greatest rejection of unwanted audio at 180 degrees off axis, which is directly behind the microphone; there is virtually no off-axis coloration. Supplied with a microphone clip that mounts to any 5/8″- 27 mic thread. It also comes with a leatherette carrying case.